Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
- The electric equipment
   Specifications
   Gymnastics system
   The generator
   Power failure check on a wire connecting the storage battery with the generator
   Check of the current developed by the generator
   Check of developed pressure
   The generator of petrol engines
   The generator of the diesel engine
   The storage battery
   Start system
   Starter of petrol engines
   Starter of the diesel engine
   Safety locks
   The block of safety locks
   The multipurpose switch
   Sound signal
   Combination of devices
   The switch of position of a lay brake
   Screen wiper and стеклоомыватель a windscreen
   Screen wiper of back glass
   Headlights and forward indexes of turn
   Forward antifog headlights and turn repeaters
   The back combined lantern
   The top stoplight
   Lantern of illumination of licence plate
   The ceiling fixture (with the hatch)
   The ceiling fixture (without the hatch)
   Lamp of illumination of salon
   Check of the relay of headlights
   Radio receiver
   Heater of back glass
   Safety pillows (SRS)
   Seat belts
   Search and elimination of malfunctions
   Specification for adjustments and the control
Electric schemes









The generator of the diesel engine

The generator of the diesel engine

1 – статор
2 – a rotor
3 – a back cover
4 – a brush
5 – an electronic regulator of pressure

6 – the rectifier
7 – a pulley
8 – a forward cover
9 – the vacuum pump


Dismantling


 PERFORMANCE ORDER

    Remove from a pulley a cover.
    The special tool remove a pulley.
    Turn out three bolts and remove the vacuum pump.
    Turn out nuts of fastening of plug "In" to a back cover, remove an insulator and turn out five bolts of fastening of a back cover.
    Turn out four coupling bolts and remove a back cover.
    If it is necessary to remove a pressure regulator, отпаяйте four wires статора from rectifier diodes.
    Separate a rotor, статор and a forward cover.

Installation

Before installation connect to the generator an oil hose.

After generator installation connect an oil hose to a branch pipe from outside the oil pallet.

Clamp a collar of fastening of a hose on a direct part of a branch pipe.

After installation of an oil tube do not bend and do not result in contact to the block of cylinders an oil tube.