Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
- The electric equipment
   Specifications
   Gymnastics system
   The generator
   Power failure check on a wire connecting the storage battery with the generator
   Check of the current developed by the generator
   Check of developed pressure
   The generator of petrol engines
   The generator of the diesel engine
   The storage battery
   Start system
   Starter of petrol engines
   Starter of the diesel engine
   Safety locks
   The block of safety locks
   The multipurpose switch
   Sound signal
   Combination of devices
   The switch of position of a lay brake
   Screen wiper and стеклоомыватель a windscreen
   Screen wiper of back glass
   Headlights and forward indexes of turn
   Forward antifog headlights and turn repeaters
   The back combined lantern
   The top stoplight
   Lantern of illumination of licence plate
   The ceiling fixture (with the hatch)
   The ceiling fixture (without the hatch)
   Lamp of illumination of salon
   Check of the relay of headlights
   Radio receiver
   Heater of back glass
   Safety pillows (SRS)
   Seat belts
   Search and elimination of malfunctions
   Specification for adjustments and the control
Electric schemes










Seat belts


retractors a seat belt

When the car has an accident under a certain corner in relation to face-to-face blow, газогенератор ignites a signal from block SRSCM.

The gas leaving from gas generator will cause piston moving to the cylinder with a tooth gearing tension.
The tooth gearing rotates a piston gear wheel, and the satellite rotates planetary gear wheels.

As a result of it the belt stretches at the expense of drum rotation. Therefore, the belt with retractors reduces weight травмирования the driver and the forward passenger at the expense of a preliminary tension of a belt. It interferes with moving of the driver and the forward passenger forward and excludes blow about a steering wheel or the panel of devices.

The terminator of loading from seat belts

The loading terminator is intended for reduction of force of blow of the driver and the forward passenger about the fastened seat belts during collision. If force of collision reaches some size, торсион preliminary tense seat belts is deformed and slightly releases a seat belt, reducing force of blow.

Removal

 PERFORMANCE ORDER

    Disconnect a wire from the negative plug of the storage battery.

Before service of system of pillows of safety be convinced that has passed not less than 30 with the ambassador of deenergizing of ignition and a detachment of a wire from the negative plug of the storage battery.

    Turn out screws of fastening of an overlay of a threshold.
    Turn out a bolt of the bottom fastening of a forward seat belt and an edge of a flat screw-driver lift upwards and remove an upholstery of an average rack.
    Turn out a bolt of the top fastening of a forward seat belt.
    Turn out a fastening bolt натяжителя a forward seat belt and remove a belt from the car.

  1. Do not assort and do not repair the module tension a seat belt.
  2. Do not drop the module tension a seat belt and do not suppose its contact to water, greasing etc. If dents, cracks are found out, deformation or corrosion, replace the module.
  3. Do not subject the module tension a seat belt to influence of temperatures above 93С.
  4. The module tension a seat belt works only once.
  5. At recycling of the worked module use goggles and gloves.