Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
- The electric equipment
   Specifications
   Gymnastics system
   The generator
   Power failure check on a wire connecting the storage battery with the generator
   Check of the current developed by the generator
   Check of developed pressure
   The generator of petrol engines
   The generator of the diesel engine
   The storage battery
   Start system
   Starter of petrol engines
   Starter of the diesel engine
   Safety locks
   The block of safety locks
   The multipurpose switch
   Sound signal
   Combination of devices
   The switch of position of a lay brake
   Screen wiper and стеклоомыватель a windscreen
   Screen wiper of back glass
   Headlights and forward indexes of turn
   Forward antifog headlights and turn repeaters
   The back combined lantern
   The top stoplight
   Lantern of illumination of licence plate
   The ceiling fixture (with the hatch)
   The ceiling fixture (without the hatch)
   Lamp of illumination of salon
   Check of the relay of headlights
   Radio receiver
   Heater of back glass
   Safety pillows (SRS)
   Seat belts
   Search and elimination of malfunctions
   Specification for adjustments and the control
Electric schemes










Screen wiper and стеклоомыватель a windscreen

Removal

 PERFORMANCE ORDER

    Remove covers and turn out nuts of fastening of levers of a screen wiper. Remove screen wiper levers.

At removal of levers of screen wipers do not scratch a cowl.

    Uncover, located under a windscreen.
    Disconnect a socket and remove the engine and draughts of a screen wiper. The inhaling moment: 7–11 Nm.

Installation

 PERFORMANCE ORDER

    Establish the screen wiper lever in certain position.
Position of installation of the lever of a screen wiper
AND
IN
Distance, mm
355
355
    Adjust nozzles of sprays so that they sprayed a liquid in strictly certain places on a windscreen.

Check

Check up conductivity between contacts of a socket of the switch of a cleaner and a windscreen washer. If conductivity does not correspond demanded, replace the switch of a cleaner and a windscreen washer.

The screen wiper switch (М01–1)

The switch стеклоомывателя (М01–1)

Check of frequency of work of a screen wiper

 PERFORMANCE ORDER

    Disconnect a socket from the screen wiper engine. Additional wires connect the positive plug of the storage battery to the plug 4 sockets, and the negative plug – to the plug 1. Be convinced that the screen wiper engine works on low frequency of rotation. Additional wires connect the positive plug of the storage battery to the plug 4 sockets, and the negative plug – to the plug 2.
    Be convinced that the screen wiper engine works on high frequency of rotation.

Check of an automatic stop of brushes in an initial condition

 PERFORMANCE ORDER

    Include the engine on low frequency of rotation. Having disconnected a wire from the plug 3 sockets, stop the engine in any position, except the initial. Connect plugs 1 and 5 sockets. Additional wires connect the positive plug of the storage battery to the plug 4 sockets, and the negative plug – to the plug 3.
    Check up that the screen wiper engine is switched off in a starting position of brushes of a screen wiper.

Check of work of the engine стеклоомывателя

 PERFORMANCE ORDER

    With the engine стеклоомывателя connected to a washer tank, fill a tank стеклоомывателя with water. Additional wires connect the positive plug of the storage battery to the plug 2 sockets, and the negative plug – to the plug 1, thus the engine should work, and the pump to swing water.