Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
- The electric equipment
   Specifications
   Gymnastics system
   The generator
   Power failure check on a wire connecting the storage battery with the generator
   Check of the current developed by the generator
   Check of developed pressure
   The generator of petrol engines
   The generator of the diesel engine
   The storage battery
   Start system
   Starter of petrol engines
   Starter of the diesel engine
   Safety locks
   The block of safety locks
   The multipurpose switch
   Sound signal
   Combination of devices
   The switch of position of a lay brake
   Screen wiper and стеклоомыватель a windscreen
   Screen wiper of back glass
   Headlights and forward indexes of turn
   Forward antifog headlights and turn repeaters
   The back combined lantern
   The top stoplight
   Lantern of illumination of licence plate
   The ceiling fixture (with the hatch)
   The ceiling fixture (without the hatch)
   Lamp of illumination of salon
   Check of the relay of headlights
   Radio receiver
   Heater of back glass
   Safety pillows (SRS)
   Seat belts
   Search and elimination of malfunctions
   Specification for adjustments and the control
Electric schemes









The multipurpose switch

Removal and installation

At removal of the multipurpose switch on the cars equipped with a pillow of safety, be cautious and satisfy following conditions.

  1. Do not assort any of components of auxiliary system of safety SRS. Dismantling of components can put safety system out of action.
  2. Exclude hit on a pillow of safety of solvents or clearing substances.
  3. Transport a safety air cushion separately, a bag upwards.
  4. If any component SRS has fallen or on it there are cracks, dents or other defects in the case, an arm or a socket, replace them with the new.
  5. At transportation do not place a hand on a safety pillow.
  6. Do not heat up the block of a pillow of safety to temperatures above 93C.
  7. After expansion of a pillow of safety replace a spiral spring of the gauge with the new.
  8. Before installation of a spiral spring of the gauge of a pillow of safety combine a label and the index of neutral position of a spring of the gauge, preliminary having established forward wheels for movement directly forward. If the label of a spiral spring is not combined properly, the steering wheel cannot turn completely or the wire of a spiral spring will be damaged, complicating normal work SRS.

 PERFORMANCE ORDER

    Remove a pillow of safety of the driver.
    Remove a steering wheel.
    Turn out screws and remove the top and bottom casings of a steering column. Turn out screws and remove the multipurpose switch.
    Installation is spent to sequences, return to removal.

Check

With the multipurpose switch in each position check up conductivity between corresponding contacts of sockets. If conductivity does not correspond demanded, replace the multipurpose switch.

The illumination switch (socket M01–2)

The switch of light of headlights (socket M01–2)

HU: a headlight of headlights
HL: a passing light of headlights
P: dimensional illumination

The turn switch (socket M01–2)

The screen wiper switch (socket M01–1)

The switch стеклоомывателя (socket M01–1)

The switch of forward antifog headlights (socket M01–2)