Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Prorolling of hydraulic system of a drive of brakes
   Adjustment of a course of a lay brake
   Brake pedal
   The vacuum amplifier of brakes
   The main brake cylinder
   Replacement of lobbies brake pads
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Lay brake
   Antiblocking system of brakes (ABS)
   Hydraulic block HECU
   The gauge of frequency of rotation of a wheel
   Prorolling of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
Body
Air central air
The electric equipment
Electric schemes










Replacement of lobbies brake pads

Removal

 PERFORMANCE ORDER

    Turn out lower bolt, lift a support upwards and fix its wire. Remove brake pads.

Do not press a pedal of a brake after removal brake pads.

Sequence of removal of lobbies brake pads

1 – a brake hose
2 – a support in gathering
3 – a brake disk

Check

 PERFORMANCE ORDER

    Check up brake pads on absence of deterioration or pollution by oil and, if necessary, replace them.

Necessarily replace all pads on one axis of the car even if one is worn out only колодка. If brake pads will be repeatedly established, before removal they are necessary for marking.

    Check up overlays brake pads on absence of damages.

Thickness of overlays brake pads:

The nominal: 11 mm
Is minimum admissible: 2,0 mm

Installation

 PERFORMANCE ORDER

    Establish clips brake pads.
    Establish brake pads on each clip brake pads.

Brake pad with the deterioration gauge establish from outside the piston.

    The special tool 09581–11000 press the piston into the support cylinder.
    Establish new brake pads.

Never put greasing on a brake disk and brake pads.

    Screw a bolt and tighten its demanded moment. The inhaling moment: 22–32 Nm.