Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
- Brake system
Specifications
Check of the vacuum amplifier of brakes
Check of the unilateral vacuum valve
Prorolling of hydraulic system of a drive of brakes
Adjustment of a course of a lay brake
Brake pedal
The vacuum amplifier of brakes
The main brake cylinder
Replacement of lobbies brake pads
Support of a forward brake
Back disk brakes
Back drum-type brakes
Replacement of the working brake cylinder
Pressure regulator
Brake tubes and hoses
Lay brake
Antiblocking system of brakes (ABS)
Hydraulic block HECU
The gauge of frequency of rotation of a wheel
Prorolling of hydraulic system of a drive of brakes with scanner use
Search and elimination of malfunctions
Body
Air central air
The electric equipment
Electric schemes
|
Back disk brakes
Removal
|
Loosen the an adjusting nut of a cable of a lay brake.
Remove a wheel.
Turn out bolts of fastening of a support (2EA).
|
5. Remove a support and brake pads. |
|
6. Remove a clip and disconnect a cable of a lay brake. |
|
|
Check
|
Check up brake pads on absence of deterioration or pollution by oil and, if necessary, replace them.
|
Necessarily replace all pads on one axis of the car even if one is worn out only колодка.
Thickness of an overlay brake pads: 9,0 mm Is minimum admissible thickness of an overlay brake pads: 2,0 mm
|
|
Check up forward both back brake pads and fastening screws on absence of deterioration or damages. At replacement pads also replace screws.
|
Check up on absence of deterioration or damages dustproof covers as if the dust has got to a support, it is necessary to replace or repair a support.
Before replacement brake pads half remove a brake liquid from a tank of the main brake cylinder.
Measure a thickness of a brake disk. By the indicator of hour type measure palpation of a brake disk on small distance from external edge.
Thickness of a brake disk:
The nominal: 10 mm Is minimum admissible: 8 mm
Maximum permissible palpation: 0,08 mm Maximum permissible difference of a thickness of a brake disk: 0,01 mm
|
- By micrometer measure a thickness of a disk in eight places, approximately through everyone 45 on distance of 5 mm from external edge of a disk.
- The indicator of hour type check up palpation of a brake disk. The indicator of hour type fix in any convenient place and, turning a brake disk, define its palpation on distance of 5 mm from external edge.
|
If necessary, replace a brake disk.
|
|
Installation
|
Check up a support and the piston on absence of deterioration, damages, cracks and a rust.
|
Check up consolidation of the piston and a cover on absence of deterioration or rupture.
|
Put the recommended greasing on following elements: – Piston consolidation: brake liquid DOT 3 or DOT 4; – An internal surface of the cylinder of a support: brake liquid DOT 3 or DOT 4; – A piston cover: brake liquid DOT 3 or DOT 4; – An external surface of the piston: brake liquid DOT 3 or DOT 4; – Covers of a directing finger: lubricant for rubber.
|
The special tool press the piston into a support.
|
|
|
|
|