Hendaj Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Prorolling of hydraulic system of a drive of brakes
   Adjustment of a course of a lay brake
   Brake pedal
   The vacuum amplifier of brakes
   The main brake cylinder
   Replacement of lobbies brake pads
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Lay brake
   Antiblocking system of brakes (ABS)
   Hydraulic block HECU
   The gauge of frequency of rotation of a wheel
   Prorolling of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
Body
Air central air
The electric equipment
Electric schemes










Prorolling of hydraulic system of a drive of brakes

 PERFORMANCE ORDER

    Uncover a compensatory tank and fill with its brake liquid.

The brake liquid dissolves a paint, plastic and isolation of wires, therefore at casual hit of a liquid on a paint and varnish covering of the car or its components wash out their considerable quantity of water.

At prorolling under pressure do not press a brake pedal

    Turn away a cover from the union of prorolling of the working brake cylinder and attach to it one end of a transparent hose, and other end of a hose insert into the glass capacity of sufficient volume half filled with a brake liquid. Slowly press a brake pedal some times.
    At the pressed pedal of a brake a key loosen the the union of prorolling also let the air out from hydraulic system. Tighten the union of prorolling and release a brake pedal.
    Repeat operations 3 and 4 until there will be a brake liquid without air vials. Tighten the prorolling union. The inhaling moment: 7–9 Nm.
    Air removal spend in the sequence shown in drawing.