Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
- Brake system
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Prorolling of hydraulic system of a drive of brakes
   Adjustment of a course of a lay brake
   Brake pedal
   The vacuum amplifier of brakes
   The main brake cylinder
   Replacement of lobbies brake pads
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Lay brake
   Antiblocking system of brakes (ABS)
   Hydraulic block HECU
   The gauge of frequency of rotation of a wheel
   Prorolling of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
Air central air
The electric equipment
Electric schemes

Prorolling of hydraulic system of a drive of brakes with scanner use

Any hydraulic system works normally if air is removed from it.


    Uncover a compensatory tank with a brake liquid.

At prorolling under pressure do not press a brake pedal

Recommended brake liquid: DOT3 or DOT4.

    Turn away a cover from the union of prorolling and attach to it one end of a transparent hose, and other end of a hose insert into the glass capacity of sufficient volume half filled with a brake liquid.
    Connect the scanner to the diagnostic socket located under the panel of devices.
    According to the scanner maintenance instruction choose the corresponding parametre.

Consider the maximum working hours of work ABS at work with the scanner to exclude перегорание the pump electric motor.

1) Establish firm hyundai the manufacturer of the car.

2) Establish the car name.
3) Establish a mode of check of antiblocking system of brakes
4) Establish a way of removal of air.

5) Press YES1 to involve the pump with the electric motor and the electromagnetic valve.

6) Wait 60 with before operation of removal of air as, otherwise, it is possible to damage the electric motor.

    Slowly press a brake pedal some times. At the pressed pedal of a brake a key loosen the the union of prorolling also wait, the brake liquid without air vials yet will not start to leave. Tighten the union of prorolling and release a brake pedal. Repeat a step 5 for removal of air from brake mechanisms of other wheels.
    Tighten the prorolling union. The inhaling moment: 7–9 Nm.