Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Prorolling of hydraulic system of a drive of brakes
   Adjustment of a course of a lay brake
   Brake pedal
   The vacuum amplifier of brakes
   The main brake cylinder
   Replacement of lobbies brake pads
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Lay brake
   Antiblocking system of brakes (ABS)
   Hydraulic block HECU
   The gauge of frequency of rotation of a wheel
   Prorolling of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
Body
Air central air
The electric equipment
Electric schemes










Replacement of the working brake cylinder

 PERFORMANCE ORDER

    Remove brake pads. Disconnect a brake tube.
    Turn out bolts and remove the working brake cylinder.
    Remove dustproof covers from the working brake cylinder. Remove the piston.
    Get a returnable spring.
    Before assemblage of the working brake cylinder check up a condition of following details:
    – The cylinder and the piston on absence of deterioration, damages and a rust;
    – The case of the working brake cylinder on absence of damages and cracks;
    – A contact surface of the piston and brake pads on absence of deterioration;
    – The piston on absence of internal porosity. Assemblage is spent in sequence, return dismantling.

  1. Before assemblage clear the working brake cylinder изопропиловым spirit.
  2. Before assemblage grease with a brake liquid the piston and the cylinder.
  3. At assemblage it is necessary to use new cuffs and dustproof covers.

Be careful not to lose a steel ball of the drainage valve.