Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
- Brake system
Specifications
Check of the vacuum amplifier of brakes
Check of the unilateral vacuum valve
Prorolling of hydraulic system of a drive of brakes
Adjustment of a course of a lay brake
Brake pedal
The vacuum amplifier of brakes
The main brake cylinder
Replacement of lobbies brake pads
Support of a forward brake
Back disk brakes
Back drum-type brakes
Replacement of the working brake cylinder
Pressure regulator
Brake tubes and hoses
Lay brake
Antiblocking system of brakes (ABS)
Hydraulic block HECU
The gauge of frequency of rotation of a wheel
Prorolling of hydraulic system of a drive of brakes with scanner use
Search and elimination of malfunctions
Body
Air central air
The electric equipment
Electric schemes
|
The main brake cylinder
Removal
|
|
Disconnect an electric socket from the gauge of level of a brake liquid.
Disconnect tubes of brake system from the main brake cylinder and close opened apertures suitable stoppers.
|
|
The brake liquid dissolves a paint, plastic and isolation of wires, therefore at casual hit of a liquid on a paint and varnish covering of the car or its components wash out their considerable quantity of water.
|
|
|
Turn away a nut of fastening of the main brake cylinder and remove the main brake cylinder. The inhaling moment: 8–12 Nm.
|
|
|
Dismantling
|
|
|
|
Remove a stopper and merge from a tank a brake liquid.
|
Turn out screws and, using a screw-driver as the lever, remove a tank from the main brake cylinder.
|
|
Screw-driver press the primary piston, get a cylindrical pin and remove the primary piston.
|
|
|
Screw-driver press the secondary piston, get a cylindrical pin and remove the secondary piston.
|
|
|
Do not assort primary and secondary pistons. |
|
|
Check
|
|
Check up an internal surface of the case of the main brake cylinder on absence of a rust and development.
Check up the main brake cylinder on absence of deterioration or damages. If necessary clear or replace the main brake cylinder.
|
|
- If the aperture of the case of the main brake cylinder is damaged, replace the main brake cylinder in gathering.
- For removal of pollution clear the case of the main brake cylinder изопропиловым spirit.
|
|
|
Assemblage
|
|
|
|
Grease with the recommended brake liquid an internal surface of the main brake cylinder and external surfaces of primary and secondary pistons.
|
Accurately insert two springs and pistons into an aperture of the main brake cylinder.
|
|
Press pistons and establish keeping ring.
|
Screw-driver press the piston and establish a cylindrical pin.
Establish two condensing rings.
|
|
With effort insert a tank into condensing rings of the main brake cylinder.
|
|
|
Installation
|
|
Establish the main brake cylinder on the vacuum amplifier of brakes.
Establish the main brake cylinder and the vacuum amplifier of brakes on a partition of a motor compartment.
Connect brake tubes to the main brake cylinder.
Attach a vacuum hose to the vacuum amplifier of brakes.
Connect draught to a pedal of a brake and establish a pin with a head and an aperture under pin and fix its new spring pinом.
Fill in a brake liquid and remove air from a hydraulic contour of brake system.
|
|
Do not try to repair the vacuum amplifier of brakes, as it of not folding type. |
|
|
|
|