Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Prorolling of hydraulic system of a drive of brakes
   Adjustment of a course of a lay brake
   Brake pedal
   The vacuum amplifier of brakes
   The main brake cylinder
   Replacement of lobbies brake pads
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Lay brake
   Antiblocking system of brakes (ABS)
   Hydraulic block HECU
   The gauge of frequency of rotation of a wheel
   Prorolling of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
Body
Air central air
The electric equipment
Electric schemes










Back drum-type brakes

Removal

 PERFORMANCE ORDER

    Remove a wheel.
    Turn away a nut of fastening of the bearing of a back wheel and remove a nave with a brake drum.
    Remove the bottom returnable spring, a clip and a spring of support brake pads.
    Remove brake pads together with a regulator.

Check

 PERFORMANCE ORDER

    Measure internal diameter of a brake drum. The indicator of hour type check up palpation of a brake drum. Replace a brake drum if internal diameter of a drum exceeds maximum permissible value.

Nominal diameter: 203,2 mm
The maximum diameter: 205,2 mm
Palpation of a brake drum: 0,05 mm
    Measure a thickness of overlays back brake pads. Replace all brake pads on one axis of the car even if only one колодка has a thickness, smaller maximum permissible.

Thickness of overlays brake pads: 4,5 mm
Is minimum admissible thickness of overlays brake pads: 1,0 mm

    Check up uniformity прилегания brake pads to a brake drum. Examine working brake cylinders on absence of leaks of a brake liquid.
    Examine a brake board on absence of deterioration or damages.

Installation

 PERFORMANCE ORDER

    With greasing grease following points of contact brake pads:
    – Points of contact brake pads with a brake board;
    – Points of contact brake pads with a basic plate.

The recommended lubricant: SAE J310, NLGI №2.

    Establish a rack of support brake pads.
    Establish returnable springs on brake pads.
    After installation of a brake drum some times tighten the lever of a lay brake.