Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
- Brake system
   Specifications
   Check of the vacuum amplifier of brakes
   Check of the unilateral vacuum valve
   Prorolling of hydraulic system of a drive of brakes
   Adjustment of a course of a lay brake
   Brake pedal
   The vacuum amplifier of brakes
   The main brake cylinder
   Replacement of lobbies brake pads
   Support of a forward brake
   Back disk brakes
   Back drum-type brakes
   Replacement of the working brake cylinder
   Pressure regulator
   Brake tubes and hoses
   Lay brake
   Antiblocking system of brakes (ABS)
   Hydraulic block HECU
   The gauge of frequency of rotation of a wheel
   Prorolling of hydraulic system of a drive of brakes with scanner use
   Search and elimination of malfunctions
Body
Air central air
The electric equipment
Electric schemes










Pressure regulator

The pressure regulator regulates pressure in a drive of brake mechanisms of back wheels depending on loading on a back axis of the car. With increase in loading it provides passage of a brake liquid to wheel cylinders of back brakes from what pressure in their contour raises and the overall performance of back brake mechanisms improves. Do not assort a pressure regulator.

Check of function of restriction of pressure

 PERFORMANCE ORDER

    Remove a regulator of pressure from the main brake cylinder. Connect two manometres, one – on the entrance party and one – on the party of an exit of a regulator of pressure.

After connection of manometres remove air from brake system.

    Press a pedal of a brake and measure entrance and target pressure.

If pressure are in limits of admissible amplitudes, as is shown in drawing, the pressure regulator is serviceable.

    Remove manometres and connect tubes of brake system in initial position and remove air from brake system.

Installation of a regulator of pressure

 PERFORMANCE ORDER

    Establish the main brake cylinder.
    Tighten connecting nuts of fastening of tubes and remove air from brake system.

The moment of an inhaling of connecting nuts: 13–17 Nm
The moment of an inhaling of nuts of fastening of a regulator of pressure: 35–55 Nm