Hyundai Elantra
- Petrol engines 1,6, 1,8 and 2,0 l
Compression check
Gear belt
Adjustment of a tension of a gear belt
Tension adjustment поликлинового a belt
Adjustment of a tension of a belt of a drive of the generator
Camshafts
Check and adjustment of backlashes of valves on engines of 1,8 and 2,0 l (MLA)
Hydraulic jacks of backlashes of valves of the engine of 1,6 l
Installation of a cover of a head of cylinders
Directing to a chain
Chain
Installation of camshafts
The mechanism of change of the moment of opening and closing of valves (CVVT) on engines of 1,8 and 2,0 l
Repair of a head of cylinders
Engine support
Removal and engine and transmission installation
The block of cylinders
Cranked shaft
Flywheel
The piston
The air filter (ACL)
Final collector
Inlet collector
System of release of the fulfilled gases
Search and elimination of malfunctions
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes
|
Tension adjustment поликлинового a belt
|
|
Check up a condition поликлинового a belt and its arrangement on pulleys.
|
|
Check up a belt tension, having pressed on it effort 100 Н in a place located on identical removal from pulleys and measure a belt deflection.
|
|
|
- Check up correctness of an arrangement of edges поликлинового a belt in flutes of pulleys.
- If at work поликлиновой the belt publishes extraneous noise, check up a belt on absence of deterioration and damages, and also working surfaces of pulleys.
|
|
|
- The belt tension should be measured precisely on the centre between pulleys.
- When the new belt is established, regulate a tension to the average value resulted in a column "New". The belt which was in the use considers the belt which has worked on the engine more of 5 mines and its tension it is necessary to regulate to the average value resulted in a column Were in the use.
- At adjustment of a tension of the belt which was in the use or the belt which has worked on the engine more of 5 mines it is necessary to regulate its tension to the average value resulted in a column Were in the use.
- At periodic surveys it is necessary to be guided by a column "Check".
|
Tension measurement by the special device of type And
|
|
At tension measurement поликлинового a belt the device should not concern other elements of the engine.
|
Tension measurement by the special device of type In
At measurement be convinced that have turned the button of repeated installation in an arrow direction to establish an arrow of the device in an initial condition.
After removal of the device from a belt of the marksman of the device will still specify a belt tension.
|
|
|
Appointment
|
Check
|
Adjustment
|
|
The new
|
Were in the use
|
| Belt of a drive of the generator |
Deflection, mm |
5,1–6,0
|
4,0–4,4
|
5,1–5,7
|
| Tension, Н |
350–500
|
650–750
|
400–500
|
Drive belt
The conditioner compressor |
Deflection, mm |
800 %
|
5,0–5,5
|
6,0–7,0
|
| Tension, Н |
250–500
|
470–570
|
320–400
|
| Belt of a drive of the pump of the amplifier of a steering |
Deflection, mm |
6,0–9,0
|
–
|
–
|
|
|