Hendaj Elantra
- Petrol engines 1,6, 1,8 and 2,0 l
   Compression check
   Gear belt
   Adjustment of a tension of a gear belt
   Tension adjustment поликлинового a belt
   Adjustment of a tension of a belt of a drive of the generator
   Camshafts
   Check and adjustment of backlashes of valves on engines of 1,8 and 2,0 l (MLA)
   Hydraulic jacks of backlashes of valves of the engine of 1,6 l
   Installation of a cover of a head of cylinders
   Directing to a chain
   Chain
   Installation of camshafts
   The mechanism of change of the moment of opening and closing of valves (CVVT) on engines of 1,8 and 2,0 l
   Repair of a head of cylinders
   Engine support
   Removal and engine and transmission installation
   The block of cylinders
   Cranked shaft
   Flywheel
   The piston
   The air filter (ACL)
   Final collector
   Inlet collector
   System of release of the fulfilled gases
   Search and elimination of malfunctions
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes










Flywheel

Removal

 PERFORMANCE ORDER

    Remove a transmission and coupling. Turn out bolts and remove a flywheel. If on the car the automatic transmission is established, remove a drive plate. At a reversing of bolts block a flywheel from проворачивания.

Check

 PERFORMANCE ORDER

    Check up a condition of a surface of the flywheel contacting to a disk of coupling. In the presence of considerable deterioration replace a flywheel. Check up palpation of a surface of the flywheel contacting to a disk of coupling. Palpation: 0,1 мм3. Check up a condition of a gear wreath of a flywheel on absence of damages and deterioration and if necessary replace it.

Installation

Establish a flywheel or a drive plate on a cranked shaft. The special tool block a flywheel from проворачивания and tighten bolts of fastening of a flywheel.

The inhaling moment: 120–130 Nm.