Hyundai Elantra
- Petrol engines 1,6, 1,8 and 2,0 l
Compression check
Gear belt
Adjustment of a tension of a gear belt
Tension adjustment поликлинового a belt
Adjustment of a tension of a belt of a drive of the generator
Camshafts
Check and adjustment of backlashes of valves on engines of 1,8 and 2,0 l (MLA)
Hydraulic jacks of backlashes of valves of the engine of 1,6 l
Installation of a cover of a head of cylinders
Directing to a chain
Chain
Installation of camshafts
The mechanism of change of the moment of opening and closing of valves (CVVT) on engines of 1,8 and 2,0 l
Repair of a head of cylinders
Engine support
Removal and engine and transmission installation
The block of cylinders
Cranked shaft
Flywheel
The piston
The air filter (ACL)
Final collector
Inlet collector
System of release of the fulfilled gases
Search and elimination of malfunctions
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes
|
Engine support
Removal
|
|
|
|
Fix captures of the load-lifting mechanism for eyes of the engine and lift so that the engine weight was perceived by the load-lifting mechanism.
|
Turn out bolts of fastening of a support of the engine.
|
|
Remove a support of the engine from the engine.
|
On cars with a mechanical transmission remove the gear change lever.
|
|
Turn out a bolt of fastening of a transmission.
|
|
|
Remove protection of an arch of the right wheel. Turn out bolts of fastening of an arm of a transmission.
|
Remove a transmission arm.
|
|
Turn out the top and bottom bolts of fastening of a forward support of the engine. Remove a forward support of the engine.
|
|
|
Turn out a bolt and remove a back support of the engine from the bottom frame.
|
|
|
Installation
|
|
Check up that the roller stopper is correctly established in the plug and does not move in it.
|
|
Establish a roller stopper.
|
|
|
Establish under a certain corner a forward support of the engine.
Cars with an automatic transmission: 303
Cars with a mechanical transmission: 143
|
|
|
Establish under a certain corner a back support of the engine.
Cars with an automatic transmission: 333
Cars with a mechanical transmission: 203
|
|
|
Plug installation
|
|
- Forward and back plugs подмоторной frames should be strictly focused.
- Be convinced that have established plugs in correct position.
|
|
|
|
|
On the top party of forward and back cross-beams there are 2 arrows defining position of plugs.
|
|
|
At installation of plugs in nests of cross-beams combine arrows on plugs with a direction of lateral elements.
|
|
|
Make sure that plugs are established to in parallel lateral elements of a cross-beam. Be convinced that the direction of installation of plugs does not deviate more, than on 3 a direction of a lateral element. |
|
|
|
|