Pushers and adjusting linings are necessary for establishing on their initial places.

Establish a chain on asterisks of camshafts how it is shown in drawing.

Before installation apply a thin film pure engine oil on all surfaces of sliding of camshafts. Establish camshafts.

Establish covers of bearings of camshafts. Check up the identification labels defining camshafts of inlet or final valves.

Camshaft of inlet valves: I
Camshaft of final valves: Е

Tighten bolts of fastening of covers of bearings the demanded moment. The inhaling moment: 14–15 Nm.

Grease with engine oil working edges and an external surface of a sealing ring and the special tool 09221–21000 establish a sealing ring on a forward part of a camshaft.

Hammer blows on the special adaptation establish a sealing ring on depth of 8,5 mm from a forward working surface of a camshaft.

Establish a pulley of a camshaft and fix its bolt. The inhaling moment: 100–120 Nm.

Combine an adjusting label of a camshaft and an adjusting label of a pulley of a cranked shaft with indexes, thus the piston of 1st cylinder will be in ВМТ in a compression step.

Establish a cover of a head of cylinders and tighten bolts of fastening of a cover the demanded moment. The inhaling moment: 8–10 Nm.

Establish a gear belt and tighten the mechanism of a tension of a gear belt.

Establish a pulley of the water pump and a pulley of a cranked shaft.