Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
- Automatic transmission
   Specifications
   Check of level of a liquid in an automatic transmission
   Liquid replacement in an automatic transmission
   Check of conductivity of the switch of ranges of a transmission (F4A42)
   The switch of ranges of a transmission and adjustment of a cable of management (F4A42)
   Check of work of the lever of the selector (A4AF3)
   Adjustment of the switch of indication of position of the lever of the selector (A4AF3)
   Check of components of an automatic transmission (F4A42)
   Testing of teamwork of an automatic transmission and the engine for the motionless car (F4A42)
   Pressure check трансмиссионной liquids (F4A42)
   Pressure check трансмиссионной liquids (А4AF3)
   Diagnostics function
   Diagnostic codes
   Adjustment of an axial backlash of a reactionary brake (F4A42)
   Adjustment of an axial backlash of a brake of the second transfer (F4A42)
   Adjustment of an axial backlash of a brake of low transfer and backing transfer (F4A42)
   Adjustment of an axial backlash of a solar gear wheel of lowering transfer (F4A42)
   Adjustment of preliminary loading of differential (F4A42)
   Elements of system of hydraulic management
   Identification of bearings of automatic transmission F4A42
   Control lamp of malfunctions (MIL)
   Identification of bearings of automatic transmission F4A43
   Adjustment of the servo-driver of compulsory inclusion of a hill-climbing gear (А4АF3)
   Pressure adjustment in a highway (А4АF3)
   Replacement of an oil sealing ring of a power shaft
   Removal and installation of transmission F4A42
   Removal and installation of transmission A4AF3
   Management of an automatic transmission
   Interlock installation
   Installation of the device of blocking of a key
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes









Check of components of an automatic transmission (F4A42)

Check of the gauge of position throttle заслонки

The gauge of position throttle заслонки is the variable resistor rotating with an axis throttle заслонки and handing over the information on which basis block ESM defines, when throttle заслонка is closed, is completely open or is in intermediate positions.

The gauge is rigidly connected to shaft throttle заслонки. Depending on position throttle заслонки resistance of the gauge changes.

Check of the gauge of temperature of oil

 PERFORMANCE ORDER

    Remove the gauge of temperature of oil.
    Measure resistance between plugs 1 and 2 sockets of the gauge of temperature of oil. Resistance:
    16,7–20,5 clod at 0C, 0,57–0,69 clod at 100C.

Check of the gauge of speed of the car

 PERFORMANCE ORDER

    Remove the gauge of speed of the car and connect resistance 3–10 clod, as is shown in drawing.
    Turn a shaft of the gauge of speed of the car and check up that there is a pressure between plugs 2 and 3 (1 turn = 4 impulses).

Check of the relay of management A/T

 PERFORMANCE ORDER

    Remove the relay of management A/T. Crosspieces connect the plug 2 relays A/T of management with negative (–) the plug of the battery and the plug 4 relays of management with positive () the battery plug. Check up conductivity between the plug 1 and the plug 3 relays of management A/T when crosspieces are connected and disconnected from the battery.
    At connection of crosspieces between relay plugs there should be a conductivity.
    At a detachment of crosspieces between relay plugs there should not be a conductivity.
    If results of check negative, replace the relay.

Check of the solenoidal valve

 PERFORMANCE ORDER

    Uncover valve cases.
    Disconnect sockets from each solenoidal valve.
    Measure resistance between plugs 1 and 2 each solenoidal valves.

Resistance:

The solenoidal valve of coupling of the shock-absorber: 2,7–3,4 Ohm at 20С
The solenoidal valve of low transfer and backing transfer: 2,7–3,4 Ohm at 20С
The solenoidal valve of the second transfer: 2,7–3,4 Ohm at 20С
The solenoidal valve of lowering transfer: 2,7–3,4 Ohm at 20С
The solenoidal valve of raising transfer: 2,7–3,4 Ohm at 20С

    If resistance of the valve differs, replace the solenoidal valve.

Resistance of solenoidal valves check, connecting an ohmmeter to socket contacts.

Contacts
Appointment
Resistance
7 and 10
The valve of coupling of the shock-absorber
2,7–3,4 Ohm at 20С
10 and 6
The valve of low transfer and backing transfer
9 and 4
The valve of the second transfer
9 and 3
The valve of lowering transfer
9 and 5
The valve of raising transfer