Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
- Automatic transmission
   Specifications
   Check of level of a liquid in an automatic transmission
   Liquid replacement in an automatic transmission
   Check of conductivity of the switch of ranges of a transmission (F4A42)
   The switch of ranges of a transmission and adjustment of a cable of management (F4A42)
   Check of work of the lever of the selector (A4AF3)
   Adjustment of the switch of indication of position of the lever of the selector (A4AF3)
   Check of components of an automatic transmission (F4A42)
   Testing of teamwork of an automatic transmission and the engine for the motionless car (F4A42)
   Pressure check трансмиссионной liquids (F4A42)
   Pressure check трансмиссионной liquids (А4AF3)
   Diagnostics function
   Diagnostic codes
   Adjustment of an axial backlash of a reactionary brake (F4A42)
   Adjustment of an axial backlash of a brake of the second transfer (F4A42)
   Adjustment of an axial backlash of a brake of low transfer and backing transfer (F4A42)
   Adjustment of an axial backlash of a solar gear wheel of lowering transfer (F4A42)
   Adjustment of preliminary loading of differential (F4A42)
   Elements of system of hydraulic management
   Identification of bearings of automatic transmission F4A42
   Control lamp of malfunctions (MIL)
   Identification of bearings of automatic transmission F4A43
   Adjustment of the servo-driver of compulsory inclusion of a hill-climbing gear (А4АF3)
   Pressure adjustment in a highway (А4АF3)
   Replacement of an oil sealing ring of a power shaft
   Removal and installation of transmission F4A42
   Removal and installation of transmission A4AF3
   Management of an automatic transmission
   Interlock installation
   Installation of the device of blocking of a key
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes









Adjustment of preliminary loading of differential (F4A42)

Place solder (approximately 10 mm in length of 3 mm in diameter) on a hydrotransformer casing as is shown in drawing.

Establish a hydrotransformer casing to картеру transmissions, without using hermetic. Tighten bolts the moment of the inhaling recommended by the specification. Turn out bolts and remove solder.

Use a micrometer for measurement of a thickness (T) the compressed solder. Choose a lining which thickness is in limits of the calculated value. A standard thickness: from (T0,045 mm) to (T0,105 mm).