It is expected that the key from the ignition lock cannot be removed from the cylinder of the lock to a detachment of a cable of blocking from the lock. For an exception of these problems at repair and service carry out following recommendations.
Assemblage of a cable of blocking and the ignition lock
The ignition lock is established on a steering column. Turn a key in the ignition lock in blocking position LOCK.
The screw connect a cable of blocking and the ignition lock.
Assemblage of a cable of blocking and the gear change lever
Establish the selector lever in position P.
b. After installation of a cable of blocking, as is shown in drawing, loosen the nut М8 of fastening of a plate of a cable of blocking so that could be turned a plate after applying of certain effort.
c. Turning a plate with the fixed cable in a direction F, eliminate cable sagging in a point B. At elimination of sagging do not pull a cable in a direction X as thus the key can not leave the cylinder of the lock of ignition. d. Tighten nut M8 of fastening of a cable of blocking.