Establish the selector lever in position N.
From outside transmissions loosen the a nut of fastening of a cable of management to the lever, for cable and control lever clearing.
|
|
Establish the selector lever in neutral position.
|
|
|
Loosen the assembly bolts of fastening of the case of the switch of ranges of a transmission, then turn the case of the switch of ranges of a transmission so that were combined an aperture on the end of a control lever and an aperture in a ledge of the case of the switch of ranges of a transmission.
|
Tighten assembly bolts of fastening of the case of the switch of ranges of a transmission the moment of the inhaling resulted in the specification. Be cautious, that at a tightening of bolts not to displace the switch case.
Softly press a cable of management of a transmission in a direction of an arrow and then tighten an adjusting nut.
Check up that the selector lever is in position N.
|
|
Check up work and functioning of the switch for each position of the lever of the selector.
|
|
|