Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
- Air central air
   Specifications
   The instruction on coolant application
   Remarks at replacement of elements of a central air of air
   Connection of elements of a central air of air
   Safety measures
   Installation of manometres for pressure measurement
   Discharge of a central air of air
   Откачка atmospheric air from a central air
   Connection of the final valve to a cylinder with a coolant
   Gymnastics of a central air of air
   Check of operational characteristics
   Oil for greasing of the compressor of the conditioner
   Check and tension adjustment поликлиновых belts
   The conditioner compressor
   The plug of coupling and pulley of the compressor of the conditioner
   The coil of excitation of coupling
   Check of a backlash of coupling
   The fan, the condenser and the relay
   Dryer-receiver
   The gauge of threefold (double) pressure
   The heating and ventilation block
   The fan
   The air filter
   Drive заслонки givings fresh / рециркулируемого air
   Check of the engine of the fan
   Relay check
The electric equipment
Electric schemes










Safety measures

    Before separation of elements of a central air of air it is necessary to prepare tools and adaptations for system service so that to leave separated system elements on as smaller time is possible. At separation of components of a central air of air immediately close connections by corresponding covers for an exception of hit of a moisture in system. All spare elements and tubes of a central air of air should be stored in tight packing. Repeatedly do not bend earlier formed tubes. All tools, the coolant distributing a collector, measuring devices and tubes should be stored in a dry and pure place.