Hendaj Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
- Air central air
   Specifications
   The instruction on coolant application
   Remarks at replacement of elements of a central air of air
   Connection of elements of a central air of air
   Safety measures
   Installation of manometres for pressure measurement
   Discharge of a central air of air
   Откачка atmospheric air from a central air
   Connection of the final valve to a cylinder with a coolant
   Gymnastics of a central air of air
   Check of operational characteristics
   Oil for greasing of the compressor of the conditioner
   Check and tension adjustment поликлиновых belts
   The conditioner compressor
   The plug of coupling and pulley of the compressor of the conditioner
   The coil of excitation of coupling
   Check of a backlash of coupling
   The fan, the condenser and the relay
   Dryer-receiver
   The gauge of threefold (double) pressure
   The heating and ventilation block
   The fan
   The air filter
   Drive заслонки givings fresh / рециркулируемого air
   Check of the engine of the fan
   Relay check
The electric equipment
Electric schemes










The instruction on coolant application

    Liquid coolant R–134a with the high maintenance of flying substances. Its hit on a skin can end обморожением, therefore at work with a coolant it is necessary to put on protective gloves. As standard measures of protection at work with a coolant it is necessary to use points for protection of eyes. At coolant hit on clothes or protective means immediately wash out the amazed place a water considerable quantity. Liquid coolant R–134a is stored in containers (cylinders). Store a cylinder with a coolant at temperature no more 52C. For check of tightness of a central air use the electronic gauge. Keep in mind that coolant R–134a after contact to a flame decays with allocation of very poisonous gas. Use only the recommended oil for greasing of elements of a central air of air as, otherwise, the system can fail. Greasing PAG intensively absorbs a moisture from atmospheric air, therefore it is necessary to observe following precautions:
    – At separation of components of a central air of air immediately close connections by corresponding covers for an exception of hit of a moisture in system;
    – At installation of new components of a central air of air remove from them protective covers directly ahead of their installation;
    – Connect tubes and hoses of a central air of air as soon as possible to reduce hit in moisture system;
    – Use greasing for air central air only from the tight container. If there was a casual discharge of a central air of air, before system service air a workplace.