Hendaj Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
- Air central air
   Specifications
   The instruction on coolant application
   Remarks at replacement of elements of a central air of air
   Connection of elements of a central air of air
   Safety measures
   Installation of manometres for pressure measurement
   Discharge of a central air of air
   Откачка atmospheric air from a central air
   Connection of the final valve to a cylinder with a coolant
   Gymnastics of a central air of air
   Check of operational characteristics
   Oil for greasing of the compressor of the conditioner
   Check and tension adjustment поликлиновых belts
   The conditioner compressor
   The plug of coupling and pulley of the compressor of the conditioner
   The coil of excitation of coupling
   Check of a backlash of coupling
   The fan, the condenser and the relay
   Dryer-receiver
   The gauge of threefold (double) pressure
   The heating and ventilation block
   The fan
   The air filter
   Drive заслонки givings fresh / рециркулируемого air
   Check of the engine of the fan
   Relay check
The electric equipment
Electric schemes










Check of operational characteristics


 PERFORMANCE ORDER

    Establish a manometre on a highway. Start the engine, leave to work on frequency of rotation of a cranked shaft of 2000 mines–1 and establish a mode of the maximum cooling at high frequency of rotation of the fan. Open all windows or doors. Establish the thermometer in a lattice of giving of air in car salon.
    Establish damp and dry thermometers as it is possible more close to an entrance aperture of the block of cooling.
    Check up that the pressure shown by a manometre, is in limits 1,373–1,575 кПа. If pressure too high, pour water on the condenser. If pressure too low, close the forward party of the condenser. Check up that air temperature in a lattice of giving of air in car salon is in limits 25–35C. Under the schedule calculate relative humidity of air, comparing temperature of damp and dry thermometers. Take temperature in a lattice of giving of air in salon of the car and calculate a difference the dry thermometer and the thermometer in a lattice of giving of air.
    Check up that if crossing of relative humidity and a difference of temperatures are in admission limits, means, air central air works normally.