Hendaj Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
- Air central air
   Specifications
   The instruction on coolant application
   Remarks at replacement of elements of a central air of air
   Connection of elements of a central air of air
   Safety measures
   Installation of manometres for pressure measurement
   Discharge of a central air of air
   Откачка atmospheric air from a central air
   Connection of the final valve to a cylinder with a coolant
   Gymnastics of a central air of air
   Check of operational characteristics
   Oil for greasing of the compressor of the conditioner
   Check and tension adjustment поликлиновых belts
   The conditioner compressor
   The plug of coupling and pulley of the compressor of the conditioner
   The coil of excitation of coupling
   Check of a backlash of coupling
   The fan, the condenser and the relay
   Dryer-receiver
   The gauge of threefold (double) pressure
   The heating and ventilation block
   The fan
   The air filter
   Drive заслонки givings fresh / рециркулируемого air
   Check of the engine of the fan
   Relay check
The electric equipment
Electric schemes










The heating and ventilation block

Removal

 PERFORMANCE ORDER

    Disconnect a wire from the negative plug of the storage battery.
    Disconnect from forward seats electric sockets and remove sitting.

At removal of forward seats do not damage an upholstery of salon of the car.

    After removal of the handle from the gear change lever, an edge of a flat screw-driver remove the top cover of the console.
    Turn out screws and remove the floor console.
    Remove lateral covers from the floor console.
    Remove a pillow of safety of the driver.

For removal of a pillow of safety look the corresponding description.

    Remove a steering wheel.
    Turn out screws of fastening of the bottom casing of a steering column and remove it.
    Remove a spiral spring of a pillow of safety of the driver.
    Disconnect a socket and remove the multipurpose switch.
    Turn out screws of fastening of a combination of devices.
    Remove an ashtray, then turn out screws of fastening of a combination of devices and remove it.
    Disconnect sockets from a combination of devices.
    Remove a combination of devices.
    Remove a radio receiver and the control panel the conditioner.
    Turn out screws of fastening of the bottom decorative panel located under the panel of devices.
    Turn out screws of fastening of the lateral decorative panel and remove it from the panel of devices.
    Remove an arm of support of the panel of devices from outside the driver.
    Turn out bolts of fastening of a steering column and remove it.
    Remove an upholstery from a forward door and the bottom furnish of a forward rack.
    Disconnect sockets from the panel of devices.
    Remove a lattice of a heater and turn out bolts of fastening of the panel of devices.
    Remove lateral covers from the bottom part of the panel of devices and turn out bolts of fastening of the panel of devices.
    Turn out bolts of fastening of the panel of devices to the central arm and a ware box.
    Turn out other bolts of fastening of the panel of devices.
    Remove the panel of devices.
    Turn out a nut of fastening of the evaporator. Remove the evaporator block. Turn out nuts of fastening of a forward cross-beam of a motor compartment and remove it. Turn out nuts of fastening of a heater. Remove the heater block.

Installation

Installation is spent to sequences, return to removal, taking into account reliable connection of all sockets.