Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
- Fuel system
- Fuel system of petrol engines
Specifications
Search and elimination of malfunctions
Check of frequency of rotation of idling
Check of the fuel pump
Replacement of the fuel filter
Replacement of the terminator of overflow (the double-thread valve)
Replacement of the gauge of level of fuel
Checks of system of injection MFI
Control lamp of malfunctions (MIL)
Diagnostic codes of malfunctions
Gauges
Fuel atomizers
The modulator of management of frequency of rotation of a cranked shaft of the engine idling (ISC)
The gauge of speed of the car (VSS)
The detonation gauge (KS)
The ignition lock (ST) and the switch of ranges (TR) in cars with an automatic transmission
The ignition lock (ST) in cars with a mechanical transmission
The engine management block
The switch and the relay of a central air of air
The electromagnetic valve of clearing of the canister of system of catching of steams of fuel (EVAP)
The main relay MFI
The ignition coil
The fuel pump
The gauge of acceleration APS
The oil valve (OCV)
Fuel highway and atomizers
Throttle knot
Fuel tank
Pedal and accelerator cable
Fuel system of diesel engines
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes
|
Fuel highway and atomizers The engine of 1,6 l
Engines of 1,8/2,0 l
Removal
|
|
|
|
Before separation топливопроводов remove pressure in fuel system as, otherwise, the fuel which is under pressure, will intensively follow from fuel system.
|
|
|
Close connection by a towel to exclude разбрызгивание the fuel, caused by residual pressure in топливопроводе. |
Remove a fuel highway together with fuel atomizers.
|
|
- At removal of a fuel highway do not drop fuel atomizers.
- At removal of fuel atomizers fuel can follow.
|
|
|
Check
|
|
Disconnect a socket from a fuel atomizer and measure resistance between socket contacts. Resistance: 15,9 0,35 Ohm at temperature 20C.
|
|
If the resistance size differs from demanded value, replace a fuel atomizer.
|
|
|
Installation
|
|
Establish on an atomizer new sealing rings.
|
|
Grease sealing rings of atomizers with fuel.
|
At installation of atomizers turn them round an axis in one and other parties.
Be convinced that atomizers are densely inserted into a fuel highway.
|
|
If the atomizer is established incorrectly, the sealing ring can be jammed. Remove an atomizer and repeatedly establish it. |
|
|
|
|