Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
- Suspension bracket
Specifications
Rack of a forward suspension bracket
The bottom lever of a forward suspension bracket
The forward stabilizer of cross-section stability
Rack of a back suspension bracket
Cross-section levers of a back suspension bracket
Longitudinal levers of a back suspension bracket
The back stabilizer of cross-section stability
Corners of installation of forward wheels
Deterioration of tyres
Shift of wheels
Check of withdrawal and course instability of the car
Wheel palpation
Tightening of nuts of fastening of a wheel
Search and elimination of malfunctions
Diagnostics of deterioration of tyres
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes
|
The back stabilizer of cross-section stability
Removal
|
|
Remove draught of the stabilizer of cross-section stability.
|
|
Turn out bolts and remove arms of fastening of the back stabilizer of cross-section stability.
|
Remove the stabilizer of cross-section stability.
|
|
Check
|
|
Check up a twisting moment which it is necessary to put for проворачивания pins of the spherical hinge of draught of the stabilizer.
|
|
|
If there are cracks in a protective cover, replace it and add greasing in the hinge.
Some times shake here and there a pin of the spherical hinge of draught of the stabilizer.
Screw on a pin of the spherical hinge самоконтрящуюся a nut and measure a twisting moment. A Dinamometrichesky key turn for самоконтрящуюся a nut a pin of the spherical hinge and on the fifth turn measure a twisting moment which it is necessary to put for проворачивания pins of the spherical hinge. A twisting moment: 1,7–3,2 Nm.
If the twisting moment exceeds admissible values, replace draught of the stabilizer.
If the twisting moment considerably below admissible value, the spherical hinge can repeatedly be used, if it is not got jammed and has no excessive люфта.
|
|
Installation
|
|
Establish the plug on the stabilizer of cross-section stability.
|
|
|
|
Combine the plug with the well-aimed put white paint on the stabilizer of cross-section stability. |
|
Level an arm in relation to the plug. Be convinced that the arm reliably covers the plug of the stabilizer of cross-section stability.
|
|
Tighten carving connections by the demanded moment.
The inhaling moment
Arm of the back stabilizer of cross-section stability: 17–26 Nm
Draught of the back stabilizer of cross-section stability: 35–45 Nm
|
|
|
|
|