Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
- Suspension bracket
   Specifications
   Rack of a forward suspension bracket
   The bottom lever of a forward suspension bracket
   The forward stabilizer of cross-section stability
   Rack of a back suspension bracket
   Cross-section levers of a back suspension bracket
   Longitudinal levers of a back suspension bracket
   The back stabilizer of cross-section stability
   Corners of installation of forward wheels
   Deterioration of tyres
   Shift of wheels
   Check of withdrawal and course instability of the car
   Wheel palpation
   Tightening of nuts of fastening of a wheel
   Search and elimination of malfunctions
   Diagnostics of deterioration of tyres
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes









The forward stabilizer of cross-section stability

Removal

 PERFORMANCE ORDER

    Remove a forward wheel.
    Remove draught of the stabilizer.
    Remove an arm of the stabilizer and the plug.
    Remove a back support of the engine.
    Remove the stabilizer of cross-section stability.

Check

 PERFORMANCE ORDER

    Check up the stabilizer of cross-section stability on absence of loss of elasticity and damages. Check up a condition of all bolts. Check up a protective cover of draught of the stabilizer on absence of cracks or damages.
    Check up a twisting moment which it is necessary to put for проворачивания pins of the spherical hinge of draught of the stabilizer.

• If there are cracks in a protective cover, replace it and add greasing in the hinge.
• Some times shake here and there a pin of the spherical hinge of draught of the stabilizer. A twisting moment: 1,7–3,2 Nm.
• If the twisting moment exceeds admissible values, replace draught of the stabilizer.
• If a twisting moment considerably below admissible value, the spherical hinge can repeatedly be used, if it is not got jammed and has no excessive люфта.

Installation

 PERFORMANCE ORDER

    Establish the plug on the stabilizer of cross-section stability.

The distance between the plug and the well-aimed put white paint should make 10 mm and settle down from car lateral aspect.

    Level an arm in relation to the plug. Be convinced that the arm reliably covers the plug. Temporarily fix an arm of the plug and establish the plug on the second party of the stabilizer.