Hendaj Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
- Suspension bracket
   Specifications
   Rack of a forward suspension bracket
   The bottom lever of a forward suspension bracket
   The forward stabilizer of cross-section stability
   Rack of a back suspension bracket
   Cross-section levers of a back suspension bracket
   Longitudinal levers of a back suspension bracket
   The back stabilizer of cross-section stability
   Corners of installation of forward wheels
   Deterioration of tyres
   Shift of wheels
   Check of withdrawal and course instability of the car
   Wheel palpation
   Tightening of nuts of fastening of a wheel
   Search and elimination of malfunctions
   Diagnostics of deterioration of tyres
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes










Cross-section levers of a back suspension bracket

Removal

 PERFORMANCE ORDER

    Remove a back wheel.
    Disconnect draught of the stabilizer of cross-section stability.
    Turn out bolts and remove the longitudinal lever of a back suspension bracket.
    Turn out a bolt of fastening of cross-section levers of a back suspension bracket to a nave support.
    Support a back beam a jack and turn out bolts of fastening of a beam to a body. Remove a back beam and levers.

Dismantling

 PERFORMANCE ORDER

    Establish special tools 09545–28100 and 09545–25000 on the cross-section lever of a back suspension bracket.
    Squeeze out the plug from the cross-section lever of a back suspension bracket.

Check

 PERFORMANCE ORDER

    Check up the plug on absence of deterioration and condition deterioration. Check up levers on absence of a bend or damage. Check up a condition of all bolts.

Assemblage

 PERFORMANCE ORDER

    Grease with a soap solution the plug and a plug installation site on the lever. The special tool 09552–25000 запрессуйте the plug in the lever.

Installation

Installation is spent to sequences, return to removal.

Tighten all carving connections by the demanded moments.

The inhaling moment:

* Bolts of fastening of the longitudinal lever of a back suspension bracket: 100–120 Nm
Bolts of fastening of an arm of the longitudinal lever of a back suspension bracket: 40–50 Nm
Bolts of fastening of an arm of the stabilizer of cross-section stability: 17–26 Н •м
Draughts of the stabilizer of cross-section stability: 35–45 Н •м
* Nut of fastening forward / back cross-section levers of a back suspension bracket: 130–150 Nm
Bolts of fastening of a back beam: 100–120 Н •м

* Carving connections which are necessary for tightening the demanded moment only after car installation on wheels are noted.