Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
Ignition system
System of preliminary heating of the diesel engine
- Coupling
Specifications
Adjustment of a pedal of coupling
Prorolling of hydraulic system of a drive of coupling
Conducted and press coupling disks
The main cylinder of coupling
Coupling pedal
The working cylinder of coupling
Search and elimination of malfunctions
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes
|
The working cylinder of coupling
Removal
|
|
Disconnect a hydraulic tube of coupling.
Turn out bolts of fastening of the working cylinder of coupling.
|
|
Check
|
|
Clear the dismantled details in solvent and blow all details and channels the compressed air.
Check up the working cylinder of coupling and covers on absence of damages.
|
|
Dismantling
|
|
Lift the receiver, a valve plate, a spring, a pusher and a cover.
Remove a dirt from an open aperture for connection of a hydraulic tube.
|
|
Remove the piston and a sealing ring (cuff), submitting compressed air through an aperture for connection of a hydraulic tube.
|
|
|
- Close an aperture of the working cylinder pure rags to catch the piston pushed out by compressed air.
- For an exception разбрызгивания a brake liquid submit air slowly.
|
|
|
Check
|
|
Check up the working cylinder of coupling on absence of damages.
Check up covers on absence of damages.
|
|
Measure internal diameter of the main cylinder of coupling. If the backlash between the piston and the cylinder exceeds admissible value, replace the main cylinder and / or the piston in gathering.
|
|
|
Measurement of internal diameter of the main cylinder of coupling spend in three sections (in the basis, the centre and top) in two perpendicular directions. A backlash: 0,15 mm. |
|
|
Assemblage
|
|
Before assemblage grease with a liquid for coupling the piston and diameter расточки the cylinder and establish the piston in gathering. A liquid: brake liquid DOT 3 or DOT 4.
|
|
Establish a valve plate, a pusher and a cover.
|
|
|
Installation
|
|
|
|
Before installation grease the plug, a pin, a washer and a pin with a head and an aperture under pin. Greasing: CASMOLY L9508.
|
|
|
Establish the cylinder of deenergizing of coupling and connect to it a hydraulic tube.
|
|
|
|
|