Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Monitoring systems and decrease in toxicity of the fulfilled gases
System of preliminary heating of the diesel engine
Power shafts, forward and back axes
Adjustment of hinges of a cowl
Luggage carrier cover
Luggage space door
The roof hatch
The panel of devices
Internal upholstery of salon
Humeral seat belt of back sitting
Zone seat belt of back sitting
Search and elimination of malfunctions
Air central air
The electric equipment
Removal and installation
Turn out a bolt of the bottom fastening of a forward seat belt and an edge of a flat screw-driver lift upwards and remove an upholstery of an average rack. The inhaling moment: 40–55 Nm.
Turn out a bolt of the top fastening of a forward seat belt. The inhaling moment: 40–55 Nm.
If the car the equipment preliminary натяжителями seat belts, disconnect a wire from the negative plug of the storage battery, disconnect a socket from gas generator and remove натяжитель a seat belt.
Installation is spent to sequences, return to removal.
- The module tension a seat belt works only once.
- Do not assort and do not repair the module tension a seat belt.
- Do not drop the module tension a seat belt and do not suppose its contact to water, greasing etc. If dents, cracks are found out, deformation or corrosion, replace the module.
- Connect a wire to the negative plug of the storage battery only after correct installation of the module tension a seat belt.
- Module removal tension a seat belt:
• Be convinced that ignition is switched off.
• Disconnect a wire from the negative plug of the storage battery and be convinced that it does not concern bodies.
• Wait 1 minute.
• Disconnect an electric socket from gas generator.
• Turn out a bolt and remove the module tension a seat belt.