Hyundai Elantra
Petrol engines 1,6, 1,8 and 2,0 l
The diesel engine of 2,0 l
Greasing system
Cooling system
Fuel system
Monitoring systems and decrease in toxicity of the fulfilled gases
- Ignition system
   Specifications
   Removal and installation of coils of ignition
   Check of the coil of ignition
   Ignition check
   Check of spark plugs
   The analysis of spark plugs
   Check of functioning of spark plugs
   High-voltage wires
   The ignition lock
   Search and elimination of malfunctions
System of preliminary heating of the diesel engine
Coupling
Mechanical transmission
Automatic transmission
Power shafts, forward and back axes
Suspension bracket
Steering
Brake system
Body
Air central air
The electric equipment
Electric schemes










High-voltage wires

Arrangement of wires

Wrong installation and arrangement of high-voltage wires can lead проскакиванию sparks from a wire on a wire or on "weight" that, in turn, can lead to admissions of ignition and reduction of frequency of rotation of a cranked shaft at car movement at great speed.

Therefore establish high-voltage wires properly, as is shown in drawings.


Check

 PERFORMANCE ORDER

    Disconnect high-voltage wires from candles and ignition coils. Clear and check up integrity of isolation of high-voltage wires. Check up internal surfaces of contacts of high-voltage wires on absence of corrosion or a deposit. By ohmmeter measure resistance of high-voltage wires.
High-voltage wires
The cylinder
№1
№2
№3
№4
Length, mm
560
440
360
310
Resistance (BOUGI), the Ohm
2,51–3,76
1,97–2,96
1,61–2,42
1,39–2,08
Resistance (R16AIPS), the Ohm
5,60–11,76
4,40–9,24
3,60–7,56
3,10–6,51

Resistance of a high-voltage wire should not exceed 10 000 Ohm, otherwise replace a wire.